Sticker Application Instructions

DISCLAIMER: Each sticker undergoes thorough inspection for quality. Rare defective products may slip through. If this happens, provide a picture of the faulty item and your order number. Once applied, the sticker becomes non-refundable.

Applying instructions:

Note:

Our stickers are designed to adhere to most surfaces, such as metal, plastic, and glass. However, surfaces with varying porosity may not allow the stickers to adhere properly.

  1. Clean the surface:

Locate the spot on the surface where you plan to stick your sticker, and give it a good scrub with either water or rubbing alcohol. Really get in there and make sure it's squeaky clean!

  1. Prepare the sticker:

After you have cleaned the surface, take the sticker still with its protective backing and find were you want the sticker to be placed. Make sure you know where you want it as it will ruin the sticker after being removed from the surface.

  1. Apply the sticker:

Now that you have found where the sticker is going, peel one side of the sticker. DO NOT pee the entire protective backing. Then apply the small section and slowly peel the rest of the backing, while using the other hand to slowly rub up and down, making sure the sticker has no air pockets and is securely on the surface. After fully applying the sticker, use your finger to rub up and down to help secure it.